New: Test line 12755 can be used for all cars, both with and without CAN-BUS/Check-Control.
Test line with load for test of trailer/ caravan sockets.
With previously known test equipment, problems can arise, when controlling sockets at cars with CAN-BUS/ Check-Control, because the load of the system is too small.
When using G.S.E.'s new test line with load these problems can be avoided.
Click for larger view |
Bestillingsnr. 12755 ISO 11446 DIN 72570 |
Following cars have CAN-BUS/Check Control:
BMW, Fiat, Ford, Mercedes, Nissan, Opel, Peugeot, VW etc.
Technical specifications:
Testing of cars with CAN-BUS systems :
Test line 12755 includes a function specific for test of cars with CAN-BUS/Electronic control systems.
* Both flash lights and the rear fog light will be activated automatically.
* Both tail lights and stop light include a constant load of 5 W.
The other functions do not include loads.
Testing of cars without CAN-BUS systems
The build-in load for test of cars with CAN-BUS/Electronic control systems will at the same time give a correct testing of cars without these systems, as the wirering and socket connections are loaded and error indications because of poor connections can be avoided.
To activate the load-function, the button "TEST" has to be pushed down.
The green light-diodes:
If test line has been activated too long the load will be overheated and a thermal fuse will turn off the load. At the same time the green light-diodes concerned will turn red. When the light-diodes turn green again, the load is reactivated.
We recommend just to push down the button ” TEST ” for shortest time possible.
Average time, before the load-function will be overheated by constant use:
Flash light/rear fog light: 1-2 min.
Other functions: 3-5 min.
Note: the functions no. 9-10-12 do not include loads.
With activated load-function:
| Right flash light: | 21 W |
| Left flash light: | 21 W |
| Rear fog light: | 21 W |
| Right tail light: | 06 W |
| Left tail light: | 06 W |
| Stop light: | 06 W |
| Reversing light: | 06 W |
Test line with load is available with the following options:
| * With 13 pin plug, ISO 11446, DIN 72570 | Order No. 12755 |
| * With 13 pin plug type "Multikon / We-St", ISO 1724 + 6 pins | Order No. 12775 |
| * With 7 pin plug, ISO 1724 | Order No. 12655 |
Adapter from 13 pin ISO 11446 to 7 pin + 6 pin ISO 1724+6 pins enables the combination of all three plug versions.
Adapter ................... Order No. 12945
The most flexible solution will be:
Test line 12755 with adapter no. 12945 ISO 11446 for WeSt plug ISO 1724 7+6, which are as well 7 and 13 pin plugs. This combination will cover any 7 and 13 pin plug combination.